Floor Scrubbers

  • The machine does not function.

    •  [Battery version] Battery connector is disconnected, the batteries are flat.
    •  [Ride On version] Emergency switch is activated.
    •  [Cable version] The machine is not plugged into the main socket.
    •  Key switch is in off position, key is missing.
  • The brush doesn’t rotate.

    •  Press the brush lever, press the brush button.
    •  Charge the batteries.
    •  Reconnect the power supply connector.
    •  [Ride On version] The brush button has not been pressed.
    •  [Ride On version] Fuse blown, motor malfunction.
  • The suction motor does not work.

    •  Switch faulty.
    •  Cable disconnected.
    •  Vacuum motor is damaged.
  • The detergent flow does notstop.

    •  The tap stays open, because it is damaged or very dirty.
    •  Faulty or dirty solenoid valve.
    •  Filter is missing or cap is open.
  • The squeegee does not clean or suction is ineffective.

    •  The edge of the rubber blades in contact with the floor is worn.
    •  The squeegee or hose is blocked or damaged.
    •  The suction hose is not connected to the squeegee or is damaged.
  • The batteries do not provide the normal work time.

    •  The battery poles and charging terminals are dirty and oxidised.
    •  The batteries are new and does not deliver 100% of its expected capacity. Perform 10 charging cycles.
    •  Batteries are exhausted and need to be replaced.
    •  [Ride On version] The battery has not been connected to the battery charger (for example, because the low voltage connector of the battery charger has been erroneously connected to the machine connector).
  • The battery charger is not working.

    •  Make sure there is voltage to the battery charger, that the fuses are not blown and that the current reaches the battery; try charging with another rectifier. If the battery charger is not working, contact the technical service centre and indicate the serial number of the battery charger.
    •  See the battery charger instructions for troubleshooting.
    •  Make sure the battery charger is correctly powered according with rated voltage.
  • The main brush does not clean the floor evenly.

    •  Main brush is worn out, have it replaced.
    •  Pad is worn out, pad holder is touching the floor.
    •  Brush head is damaged, contact the technical service.
  • The machine leave scratches on the floor.

    •  Brush or Pad are worn out, plastic disc touches the floor causing scratches.
    •  The brush or Pad are not suitable for application, try with a softer type.
    •  Brush is missing and metal parts interfere with the floor.

Vacuum Sweepers

Commercial Vacuums